Hp StorageWorks 2405 Disk System Manuel d'utilisateur télécharger pdf (Page 116)

116 Removal and Replacement

Caution Replace the disk module or filler immediately (see next step).

Caution Touching the disk circuit board can cause high energy discharge

and permanently damage the disk.

Disk modules are fragile. Handle carefully.

3 Remove the replacement disk module from its ESD bag, being careful to

grasp the disk module by its extraction handle (see Figure 57). (Fillers are not

in ESD bags.)

4 Press the cam latch toward the end of the extraction handle to loosen the

extraction handle.

When you are installing a disk module filler, align the disk filler guides with

the chassis rails and insert the filler. Push the filler in until it stops. When it is

fully inserted, it will be flush with the rest of the disk modules/disk module

fillers.

5 Slide the disk module, capacity label up, into the empty slot.

6 Press the extraction handle to seat the disk module firmly on the midplane.

An audible click indicates the disk module is fully seated.

If you are installing a disk module (as opposed to a filler), monitor the LEDs.

It should be on while the disk spins up and then turn off. The LED will blink

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 143 144

Pas de commentaire

Hp StorageWorks 2405 Disk System Manuel d'utilisateur Page 116