Hp StorageWorks IP Storage Router Manuel d'utilisateur télécharger pdf (Page 28)

Installation

28 IP Storage Router SR2122-2 User Guide

Site Planning

Planning the proper location and layout of your SR2122-2, your equipment rack,

or wiring closet is essential for successful storage router operation. Equipment

placed too close together or in a poorly ventilated area can cause the system to

overheat. In addition, poor equipment placement can make system panels

inaccessible and difficult to maintain.

Table 20 in Appendix A lists the operating and nonoperating environmental site

requirements for the SR2122-2. Within specified environmental ranges, the

system can continue to operate; however, a measurement that approaches the

minimum or maximum of a range indicates a potential problem. You can maintain

normal operation by anticipating and correcting environmental conditions before

they exceed the maximum operating range.

Verify the site power for the type of device you are installing. Power requirements

are useful for planning the power distribution system needed to support the

storage router. Heat dissipation is an important consideration for sizing the

air-conditioning requirements for an installation. See Table 20 in Appendix A for

power and heat ratings for the SR2122-2.

Caution: To prevent a loss of input power, verify that the total maximum load

on the circuit supplying power to the power supply is within the current ratings

of the wiring and breakers.

Installing the Storage Router

You can install the SR2122-2 on a table or a shelf, or in an equipment rack. The

following sections describe the steps required to install the storage router:

■ Installing on a Table or a Shelf

■ Rack-Mounting the Storage Router

■ Installing SFP Modules

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 241 242

Pas de commentaire

Hp StorageWorks IP Storage Router Manuel d'utilisateur Page 28