HP Smart Array (RAID) Host Bus Adapters Manuel d'installation télécharger pdf (Page 17)

2. Use saupdate UPDATE to update the firmware on the controller.

To update a single controller, the syntax of the saupdate UPDATE command is as follows:

saupdate UPDATE <seg:bus:dev:func> <smartarray_firmware_file>

For example, to update the controller at segment 1, bus E4, device 0, function 0 from the

example output above:

fs0:\> saupdate UPDATE 1:E4:0:0 sandman.bin

To update all controllers of the same model in the server, the syntax of the saupdate UPDATE

command is as follows:

saupdate UPDATE <model> <smartarray_firmware_file>.

For example, to update all Smart Array P411 controllers in the system:

fs1:\> saupdate update P411 sandman.bin

********************************************************************************

Smart Array Offline Firmware Update Utility

Version 2.09.10.02

********************************************************************************

Updating controller in Seg: 1, Bus: 71, Dev: 0, Func: 0

Current firmware version 3.22 Build 0

Percentage completed: 100%

Activating firmware now, this may take several minutes.

Resetting and reinitializing controller.

Retrieving firmware version, this may take several minutes.

Current controller firmware version is 3.26 Build 0

********************************************************************************

Smart Array Offline Firmware Update Utility

Version 2.09.10.02

********************************************************************************

Updating controller in Seg: 1, Bus: E4, Dev: 0, Func: 0

Current firmware version 3.22 Build 0

Percentage completed: 100%

Activating firmware now, this may take several minutes.

Resetting and reinitializing controller.

Retrieving firmware version, this may take several minutes.

Current controller firmware version is 3.26 Build 0

You can also update all controllers in the server that are supported by a firmware file. The

syntax of the saupdate UPDATE command is as follows:

saupdate UPDATE all <smartarray_firmware_file>.

Verifying the firmware update

To verify that the firmware update was successful, follow these steps:

1. After updating the firmware, cycle the power on the system and on any external JBODS

connected to the system.

Verifying and updating controller firmware offline 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Pas de commentaire

HP Smart Array (RAID) Host Bus Adapters Manuel d'installation Page 17