HP MSL5026 Manuel d'utilisateur Page 43
- Page / 216
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Installation
43HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Note: For HP rack system/e and AlphaServer H9A rack enclosures, refer to the
appropriate rack rail adapter kit.
2. Remove the template and then attach the rails using the supplied fasteners (see
Figure 12). The front rail brackets are threaded to directly accept screws. The
rear brackets are not threaded and require cage/clip nuts in the rack enclosure
rear vertical rails.
Note: Refer to the Compaq Rack Products Reference Guide for detailed cage nut
installation instructions on 7000/9000/10000 racks.
Note: Fully tighten the front rail screws. Leave the rear rail screws “finger tight” to
prevent binding when mounting the library.
a. Fully extend the slide rails 1 on both sides of the rack enclosure until they
lock.
b. Slide the inner guide rail 2 as far as possible to the front of the rail
assembly.
- MSL5000 and MSL6000 series 1
- Fourth Edition (April 2003) 2
- Part Number: 231910-004 2
- Contents 10
- About this Guide 13
- Related Documentation 14
- Conventions 14
- Equipment Symbols 15
- Rack Stability 16
- Getting Help 17
- Introduction 19
- Accessories 20
- Tape Drives 21
- Ultrium Tape Drives 22
- Ultrium Tape Cartridges 22
- DLT and SDLT Tape Drives 24
- DLT Tape Cartridges 25
- SDLT Tape Cartridges 26
- Magazines 27
- Power Supplies 28
- Robotics 30
- Library Controller Board 31
- 1 Library Controller Board 32
- Front Panel Indicators 35
- Multi Unit Library Systems 36
- 1 PTM Interface Connector 37
- Installation 39
- Setting Up the Tabletop Model 40
- 1 Left Retaining Screw 46
- 2 Right Retaining Screw 46
- Applying Power to the Library 47
- Supported SCSI Cables 49
- 2 To Library Controller Board 50
- 3 To Host System 50
- 1 SCSI Terminator 50
- Setting a SCSI ID 55
- Setting Up a Reserved Slot 58
- To reserve a slot: 61
- Front Panel 68
- 2 Library Status LED 69
- Indicators 70
- GUI Touch Screen 71
- Host System 72
- Initialization Screen 73
- Library Status Screen 74
- Technical Support Information 75
- Magazine Access 77
- GUI Contrast Controls 78
- Figure 45: Menu screen 81
- Library Options 82
- SCSI Options 85
- Network Options 90
- Library Info 91
- Cartridge Map 91
- Edit Options Area 93
- Passwords 95
- Diagnostics 97
- Security Level 98
- Removing Magazines 99
- Operation 100
- 1 Left-hand Magazine(s) 100
- 2 Right-hand Magazine(s) 100
- 1 Mail Slot Holder 102
- 1 Tape Cartridge 102
- Ultrium Labels 103
- (seeFigure 62) 104
- SDLT and DLT Labels 105
- Media Label Identifiers 106
- Remote Management 107
- Interface 107
- Overview 108
- Remote Management Interface 109
- Figure 66: Status screen 111
- Using Menu Buttons 112
- Move Media 113
- Figure 68: Setup screen 114
- Library Configuration 115
- SCSI Configuration 116
- Drive Configuration 117
- Functions 118
- Figure 73: History screen 119
- Maintenance 121
- Maintaining Tape Cartridges 123
- Ultrium Cartridges 124
- DLT and SDLT Cartridges 124
- Worn (Do Not Use) 126
- Running a Cleaning Cartridge 127
- Type box 132
- Updating Firmware 133
- Firmware Flashing Procedure 135
- Troubleshooting 137
- Identifying Platform Problems 138
- Performing Error Recovery 139
- Fault Symptom Codes (FSCs) 140
- Regulatory Compliance 179
- Class A Equipment 180
- Class B Equipment 180
- Modifications 181
- United States only 181
- European Union Notice 182
- BSMI Class A Notice 183
- Japanese Notice 183
- Laser Device 183
- Laser Safety Warnings 184
- Laser Specifications 184
- Laser Regulation Labels 185
- Regulatory Compliance Notices 186
- Specifications 187
- Mechanical 189
- Environmental (All Models) 190
- Acoustics 192
- Safety and Regulatory 193
- Electrostatic Discharge 195
- Grounding Methods 196
- Configuration Examples 197
- SCSI Cable Configurations 198
- Optional Fibre Channel Card 203
- Host Prerequisites 204
- Connectors and Indicators 205
- Serial Port 206
- Ethernet Port 206
- Fibre Channel Port 206
- SCSI VHDCI Connectors 206
- Configuration 207
- Figure 89: Reset switch 209
Produits connexes et manuels pour Non HP MSL5026
Non HP M1120 Comment utiliser
(1 pages)
(1 pages)
Non HP 82160A Manuel d'utilisateur
(13 pages)
(13 pages)
Non HP DL580 Livre blanc
(12 pages)
(12 pages)
Non HP W6000 Manuel d'installation
(2 pages)
(2 pages)
Non HP tc2120 Guide de l'utilisateur
(9 pages)
(9 pages)
Non HP Mz67 Manuel de démarrage rapide
(136 pages)
Non HP rp7410 Guide de démarrage rapide
(46 pages)
(46 pages)
Non HP Switch 3235 Manuel d'utilisateur
(82 pages)
(82 pages)
(14 pages)
Non HP Deskjet 6520 Manuel d'utilisateur
(2 pages)
(2 pages)
Non HP PL4200N Manuel d'utilisateur
(1 pages)
(1 pages)
Non HP V5040u Manuel de démarrage rapide
(1 pages)
(1 pages)
Non HP A3311A Manuel d'utilisateur
(149 pages)
(149 pages)
Non HP ColorFlex 13-1 Manuel d'utilisateur
(24 pages)
(24 pages)
Non HP 8447A Manuel d'utilisateur
(30 pages)
(30 pages)
Non HP NSARPA/1000 Manuel d'utilisateur
(208 pages)
(208 pages)
Non HP FIPS 140-2 Manuel d'utilisateur
(26 pages)
(26 pages)
Non HP SP400 Manuel d'installation
(1 pages)
(1 pages)
Non HP Landscape Lighting B Manuel d'utilisateur
(258 pages)
(258 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.049 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels