HP 5SI Manuel d'utilisateur Page 94

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 199
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 93
Stapling Documents
The stapler can staple documents of 2 to 20 pages on 16 lb. to 20 lb.
paper, Letter and A4 size only. The stapler should not be set as the
default output bin. If your job is only one page, or if it is greater than 20
pages, the mopier will print your job to the bin, but it will not be stapled.
The stapler bin can hold up to 350 stapled sheets. To have your job
stapled, send it to OPTIONAL OUTBIN 7.
Selecting the Stapler through the Software
You can select the stapler through your software application or printer
driver. This is the recommended method for stapling. If you are unable
to designate the paper destination in your software or printer driver,
follow the instructions below for setting the overall default mopier
output bin selection.
Note Where and how you make selections depends on your software
application or associated printer driver. The selection process may be
available only from within the printer driver. See Chapter 3, “Mopier
Software,” or your application manual for more information.
Selecting the Stapler as default destination from the
Control Panel
If your software does not support stapling, set it using the directions
below.
1 Press [Menus] repeatedly until CONFIGURATION MENU appears.
2 Press [Items] repeatedly until PAPER DESTINATION= TOP OUTPUT
BIN * appears.
3 Press [+] repeatedly until PAPER DESTINATION= OUTBIN 7 appears.
Your network administrator may have changed the name of this bin. For
example, it may be called STAPLER.
4 Press [Select]*] to save your choice. An asterisk (*) appears next to
your selection.
5
Print Tasks
EN Print Tasks 5-29
Vue de la page 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 198 199

Commentaires sur ces manuels

Pas de commentaire