HP RX2600 Manuel d'utilisateur télécharger pdf (Page 74)

Version 1.2 Page 60 4/22/04

Specifying SCSI Parameters

The following SCSI parameters may be configured for the SCSI board:

o SCSI ID (SCSI initiator ID)

o Maximum data transfer rate (SCSI rate)

o Bus width

o Whether the HBA is bootable (driver support)

o Avoid bus resets (secondary cluster server)

Using the SCSI Setup Utility

Step 1: At the EFI shell prompt, type this command to map the parameters for all PCI cards installed in the

system:

info io

A list of all the devices that are installed in the hp rx2600 server and managed by EFI drivers is displayed.

The output may look like this:

Shell> info io

I/O INFORMATION

BOOTABLE DEVICES

Order Media Type Path

----- ---------- ---------------------------------------

1 HARDDRIVE

Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0)/HD(Part1,SigC1)

Seg Bus Dev Fnc Vendor Device Slot

# # # # ID ID # Path

--- --- --- --- ------ ------ --- -----------

00 00 01 00 0x1033 0x0035 XX Acpi(HWP0002,0)/Pci(1|0)

00 00 01 01 0x1033 0x0035 XX Acpi(HWP0002,0)/Pci(1|1)

00 00 01 02 0x1033 0x00E0 XX Acpi(HWP0002,0)/Pci(1|2)

00 00 02 00 0x1095 0x0649 XX Acpi(HWP0002,0)/Pci(2|0)

00 00 03 00 0x8086 0x1229 XX Acpi(HWP0002,0)/Pci(3|0)

00 20 01 00 0x1000 0x0030 XX Acpi(HWP0002,100)/Pci(1|0)

00 20 01 01 0x1000 0x0030 XX Acpi(HWP0002,100)/Pci(1|1)

00 20 02 00 0x14E4 0x1645 XX Acpi(HWP0002,100)/Pci(2|0)

00 40 01 00 0x1000 0x0021 03 Acpi(HWP0002,200)/Pci(1|0)

00 40 01 01 0x1000 0x0021 03 Acpi(HWP0002,200)/Pci(1|1)

00 E0 01 00 0x103C 0x1290 XX Acpi(HWP0002,700)/Pci(1|0)

00 E0 01 01 0x103C 0x1048 XX Acpi(HWP0002,700)/Pci(1|1)

00 E0 02 00 0x1002 0x5159 XX Acpi(HWP0002,700)/Pci(2|0)

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 83 84

Pas de commentaire

HP RX2600 Manuel d'utilisateur Page 74