HP 5300 Guide d'installation télécharger pdf (Page 21)

HP ProCurve Switch xl Modules

Installing the Modules

PoE Module LEDs

Port LEDs

There are two LEDs for each port:

■ The Link LED lights with a valid 10base-T or 100base-TX connection.

■ The Mode LED lights according to the LED mode selected on the chassis

and the LED mode selected on the HP ProCurve Switch PoE xl module.

If the module’s LED mode selection is Std (standard), then the Mode LED

behaves as other HP ProCurve switch modules:

If the module’s LED mode is PoE, the Mode LED provides information on the

status of the PoE connection for that port:

■ If the Mode LED in on the port is providing PoE power.

■ If the Mode LED is off the port is not providing PoE power.

Status LEDs

There are two status LEDs:

■ PoE - lights when PoE power is being supplied to one or more PDs. It goes

out when there are no valid loads attached to any of the ports. It will blink

to indicate an error on any of the ports or when any port is denied PoE

power.

■ EPS - lights when the module is connected to an HP 600 RPS/EPS or an

HP 610 EPS. It goes out when the HP 600 RPS/EPS or HP 610 EPS is

disconnected from the module. It blinks when there is an error on the HP

600 RPS/EPS or HP 610 EPS or it is over-subscribed, more PoE power is

needed than the HP 600 RPS/EPS or HP 610 EPS can supply.

Chassis Mode

Switch Setting

Description Port Indication - LED On

Act Activity Transmit or Receive Traffic Present

FDx Full Duplex Full Duplex Mode of Operation

Max Maximum Speed Operation in 100Mbps

! Attention Experiencing any of a fixed set of

errors

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Pas de commentaire

HP 5300 Guide d'installation Page 21