HP 5300 Spécifications télécharger pdf (Page 48)

3-2

Getting Started With Switch Configuration

Getting Started With Switch

Configuration

Note By default, the switch is configured to acquire an IP address configuration

from a DHCP or Bootp server. To use DHCP/Bootp instead of the manual

method described in this chapter, see “DHCP/Bootp Operation” in the

Management and Configuration Guide which is on the Documentation CD-

ROM that came with your switch.

Using the Switch Setup Screen

The quickest and easiest way to minimally configure the switch for manage-

ment and password protection in your network is to use a direct console

connection to the switch, start a console session, and access the Switch Setup

screen.

1. Using the method described in the preceding section, connect a terminal

device to the switch and display the switch console command (CLI)

prompt (the default display).

The CLI prompt appears displaying the switch model number:

HP ProCurve Switch 5308xl

2. At the prompt, enter the setup command to display the Switch Setup

screen. The following illustration is an example of a Setup screen with

default settings.

3. Use the Tab key to select the Manager Password field and enter a manager

password of up to 16 characters.

imeP Mode [Disabled] : Disabled

IMEP

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

Pas de commentaire

HP 5300 Spécifications Page 48