HP Integrity rx2600 Informations techniques télécharger pdf (Page 46)

HP Integrity rx2620 Upgrade

System Hardware Component Upgrade Instructions

Chapter 1

Upgrading the CPUs

Installing the New Processor Module

Step 1. Verify part number of the CPU (AB334A, AB335A or AB336A).

NOTE Ensure that each processor has an identical part number when installing more than

one processor. CPU types cannot be mixed within the same server.

Step 2. Ensure that socket covers are removed and that sockets are in the unlocked position. See

“Removing Processor Modules” on page 31 for more detail.

Step 3. Use the four locator posts on the heatsink and the turbo fan power cable to properly align the fan

and processor module on the system board. The four locator posts will fit in locator holes on the

system board processor module mount. The turbo fan power cable must be positioned so that it is

located on the side of the heatsink that faces the front of the system.

Figure 1-37 Aligning the Processor Module

CAUTION Do not press the processor module into the socket. When properly aligned, the

processor pins will seat into the ZIF socket, no additional pressure is required.

Step 4. Use the special processor tool shipped with your processor module to lock the processor module in

place on the system board. To do this, insert the special processor tool into the hole that runs down

the side of the heatsink and rotate it clockwise 180 degrees.

Front of Chassis

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 68 69

Pas de commentaire

HP Integrity rx2600 Informations techniques Page 46