HP Integrity rx2600 Informations techniques télécharger pdf (Page 50)

HP Integrity rx2620 Upgrade

System Hardware Component Upgrade Instructions

Chapter 1

Figure 1-44 Connecting the Power Pod Cable

Reinstalling System Fans, PCI Card Cage, Airflow Guides, Memory, and the

Management Processor

Reinstall the Management Processor

NOTE Connect SCSI cables before replacing the Management Processor.

Step 1. Insert the management processor in the system.

Step 2. Grasp its edges and place it on the two management processor posts.

Step 3. Push the 10/100 management LAN, 15-pin VGA and 25-pin serial connectors through their

openings on the back of the system

Step 4. Connect the management processor:

• Connect the management processor cable to its connector on the system board.

• Screw in the two mounting screws that connect the management processor to the internal

chassis post.

• Screw in the two external mounting screws that are located on both sides of the 25-pin serial

connector.

Step 5. Replace the power connectors in their slots on the back of the system and screw in the power

connector mounting screws.

Front of Chassis

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 68 69

Pas de commentaire

HP Integrity rx2600 Informations techniques Page 50