Hp Designjet T1120 Printer series Manuel d'utilisateur Page 37

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 207
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 36
Turn the printer on and off
TIP: The printer can be left powered on without wasting energy. Leaving it on improves response time
and overall system reliability. When the printer has not been used for a certain period of time, it saves
power by going into sleep mode. However, any interaction with the printer's front-panel display returns
it to active mode, and it can resume printing immediately. To change the sleep mode time, see
Change
the sleep mode setting on page 30.
NOTE: In sleep mode, the printer performs maintenance service to the printheads from time-to-time.
This avoids long preparation times after long idle periods. Therefore, it is strongly recommended to leave
the printer powered on or in sleep mode to avoid wasting ink and time.
The printer has three levels of power consumption.
Plugged in: the power cord is plugged into the back of the printer
Switched on: the switch at the back of the printer is in the on position
Powered on: the Power key on the front panel shows a green light
If you wish to turn the printer on or off or reset the printer, the normal and recommended method is to
use the Power key on the front panel.
However, if you plan to store the printer indefinitely or the Power key does not seem to work, you are
recommended to power it off using the Power key, and then also switch off the power switch at the rear.
To turn it back on, use the power switch at the rear.
28 Chapter 4 Personalizing the printer ENWW
Personal settings
Vue de la page 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 206 207

Commentaires sur ces manuels

Pas de commentaire