Hp e-CommerceXML Accelerator sa7150 Manuel d'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 212
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
C H A P T E R 2 HP e-Commerce/XML Server Accelerator SA7150 User Guide
10
Free-Standing
Installation
1. Attach the provided self-adhesive rubber feet to the SA7150s
bottom.
2. Place the SA7150 on a flat surface and make sure that there is
adequate airflow surrounding the unit (allow at least one inch of
air space on all sides).
Network
Connections
1. Use the table below to select and install the appropriate network
cables (Category 5 UTP or better):
NOTE: Never connect
both of the SA7150s
network ports to the same
switch, hub, or router.
Doing so creates a
feedback loop that
adversely effects network
bandwidth.
2. Connect the provided power cable to the back of the unit. (There
is no power switch.) Under normal circumstances, the SA7150
requires approximately 30 seconds to boot. When the boot is
complete, the units Power LED is steadily illuminated. (If the
Power LED is not steadily illuminated, see Chapter 9,
Troubleshooting, to rectify before proceeding to Step 3.)
3. The Inline LED should be either steadily illuminated or blinking
(to indicate Inline mode). If it is not, press the Bypass switch on
the devices front panel to enable Inline mode.
SA7150’s network
connector
SA7150’s server
connector
Workstation or Server Crossover cable Straight-through cable
Switch or Hub Straight-through cable Crossover cable
Router Crossover cable Not recommended
SA7150 network
connector*
N/A Straight-through cable
SA7150 server
connector*
Straight-through cable N/A
* Applicable only to multiple, cascaded units
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 211 212

Commentaires sur ces manuels

Pas de commentaire