Hp Integrity NonStop H-Series Manuel d'utilisateur télécharger pdf (Page 29)

Troubleshooting

M8705A Tape Drive Installation and User’s Guide—694638-001

5-5

Understanding LED Sequences

Tape FLASHES

The drive believes the

current tape or the tape

just ejected is faulty.

Unload the tape cartridge.

Make sure that you are using

the correct format cartridge;

an Ultrium data cartridge or

Ultrium Universal Cleaning

Cartridge.

Reload the cartridge. If the

Tape LED still flashes or

starts flashing during the next

backup, load a new or known

good cartridge.

If the Tape LED is now off,

discard the 'suspect' tape

cartridge. If it is still on, call

for service.

The tape is ejected

immediately and Tape

FLASHES, or Drive

FLASHES on unloading

tape.

The tape cartridge

memory (CM) may be

faulty.

Write protect the cartridge by

sliding the switch on the tape

cartridge, see Write

Protecting Cartridges on

page 4-7 The tape can be

loaded and the data read.

Once the data is recovered,

the cartridge must be

discarded.

Table 5-1. Clean, Tape, Drive and Ready LED Sequences

LED Sequence Cause Action Required

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Pas de commentaire

Hp Integrity NonStop H-Series Manuel d'utilisateur Page 29