Hp Netserver E Server series Manuel d'utilisateur télécharger pdf (Page 10)

Chapter 1 Installation Overview

Cooling Duct/Cover

Hook

Fan Cable

Power Supply Harness

Figure 1-2. Removing the Cooling Duct/Cover

Install Additional Memory

Use HP SIMMs listed on the Technical Reference Card, located in the pouch on

the side of the chassis.

CAUTION Wear a wrist strap and use a static-dissipating work surface

connected to the chassis when handling components.

1. Align the notched corner on the SIMM with the key on the end of the slot

and insert the SIMM at a 45-degree angle, as shown in Figure 1-3.

2. Pivot the SIMM to the 90-degree angle until the retaining clips on both

sides snap into place.

3. If the cooling duct/cover was removed, replace it before replacing the

NetServer cover.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 96 97

Pas de commentaire

Hp Netserver E Server series Manuel d'utilisateur Page 10