Hp Netserver E Server series Manuel d'utilisateur télécharger pdf (Page 12)

Chapter 1 Installation Overview

8. The Tested Products List then displays. Click any product for which you

want to find information.

You can identify a board by the shape of its connector:

Figure 1-4. Connector Identification

Install Additional Mass Storage Devices

If you are installing an IDE drive or internal SCSI devices in certain

configurations, you may need additional cables or adapters. For part numbers for

HP cables, adapters, and trays, and configuration information, see Information

Assistant on the Navigator CD-ROM. For new products, you can use Order

Assistant on the HP web site at this URL:

http://www.hp.com/netserver/order/config/od_asst.htm

Configure the HP NetServer

1. Reassemble the HP NetServer and connect the power cord.

2. If you have installed ISA non-plug-and-play adapter boards, you must

now allocate memory resources to each of these boards. Refer to the

"Installing ISA Non-Plug-and-Play Boards" in Chapter 4, "Accessories,"

for instructions.

3. Turn on the HP NetServer and monitor.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 96 97

Pas de commentaire

Hp Netserver E Server series Manuel d'utilisateur Page 12