Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 26)

Chapter 4 Accessory Boards

preferred slot locations. If not, consider the boot order (see Figure 4-3)

when choosing the accessory board socket in which to install the board.

Figure 4-3. Accessory Board PCI and ISA Slots

Boot order for PCI controllers is determined by slot location. The system

searches for a bootable device in the following order:

a. IDE CD-ROM drive with a bootable CD-ROM.

b. Flexible disk drive with a bootable flexible disk.

c. Embedded SCSI controller or HP integrated NetRAID controller.

d. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.

This boot order can be changed using the Setup utility (press [F2] during

the boot process).

2. Remove the slot cover for each slot to be used, and store it for future use.

If you are installing any full-length PCI boards, also remove the accessory

board retainer (see Figure 4-4). Push on the tab on the retainer to release

it, and then slide it out of the board guide.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 125 126

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 26