Hp Netserver L Server series Manuel d'utilisateur télécharger pdf (Page 39)

Chapter 4 Installing Mass Storage

• Remove the drive's termination jumper. (The SCSI cable to the

internal drives is terminated.)

For instructions, refer to the disk drive's installation guide.

3. Choose the drive bay that the device will occupy. Remove the filler panel

that covers the bay.

4. Reach into the bay and pull out the data communication cable and a power

cable.

The three drive bays are served by one SCSI data cable with several

connectors, and by several free power cables. Select the SCSI connector

and power cable that are nearest to the drive bay you selected.

5. Hold the drive in front of the drive bay (Figure 4-1). Connect the SCSI

data cable and the power cable to the rear of the drive.

Figure 4-1. Installing a Hard Disk Drive

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 146 147

Pas de commentaire

Hp Netserver L Server series Manuel d'utilisateur Page 39