Hp NonStop G-Series Manuel d'utilisateur télécharger pdf (Page 76)

Switch Command Interface (SWCI)

ServerNet Nomadic Disk (Release 2) User’s Guide—523968-001

6-6

Starting SWCI

1. Before starting SWCI, review these considerations:

•

You must be a super-group user (255, n) to run SWCI.

•

When you start SWCI, SWCI checks for the device specified in the RUN

command. If that device exists, SWCI checks the device type and subtype,

which must be type 6 (terminal type), subtype 0 (asynchronous serial device).

•

If the device type and subtype are incorrect, SWCI returns an error

message.

•

If the specified device name does not exist on the specified node, SWCI

returns an error message and terminates.

2. Start SWCI from a terminal connected to a server.

•

To start SWCI from a NonStop S-series server directly connected to a specific

switch module, at a TACL prompt, type:

1> RUN $SYSTEM.SYSTEM.SWCI $switchmoduledevice

where:

$switchmoduledevice

is the device name of the switch module

At startup, SWCI displays the command prompt:

SWCI $switchmoduledevice >

For example:

1> RUN $SYSTEM.SYSTEM.SWCI $NDSWA.#TERM

starts SWCI and displays the command prompt:

SWCI $NDSWA.#TERM >

Note. Although it is possible to run SWCI from other servers connected to the switch module,

NonStop S-series servers are the only servers documented in this guide.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 147 148

Pas de commentaire

Hp NonStop G-Series Manuel d'utilisateur Page 76