Hp ProLiant BL465c G7 Server-Blade Manuel d'utilisateur télécharger pdf (Page 15)

Operations 15

Remove the access panel

To remove the component:

1. Power down the server blade (on page 13).

2. Remove the server blade (on page 14).

3. Lift the access panel latch and slide the access panel to the rear.

4. Remove the access panel.

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION: To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.

Install the access panel

1. Place the access panel on top of the server blade with the hood latch open. Allow the panel to

extend past the rear of the server blade approximately 0.8 cm (0.2 in).

2. Engage the anchoring pin with the corresponding hole in the latch.

3. Push down on the hood latch. The access panel slides to a closed position.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 97 98

Pas de commentaire

Hp ProLiant BL465c G7 Server-Blade Manuel d'utilisateur Page 15