Hp ProLiant DL320 G3 Server Manuel d'utilisateur Page 99
- Page / 119
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Regulatory compliance notices 99
Class B equipment
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit that is different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
Declaration of conformity for products marked with
the FCC logo, United States only
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
For questions regarding this product, contact us by mail or telephone:
• Hewlett-Packard Company
P. O. Box 692000, Mail Stop 530113
Houston, Texas 77269-2000
• 1-800-HP-INVENT (1-800-474-6836). (For continuous quality
improvement, calls may be recorded or monitored.)
For questions regarding this FCC declaration, contact us by mail or telephone:
- User Guide 1
- Audience assumptions 2
- Contents 3
- Front panel components 7
- Front panel LEDs and buttons 8
- Rear panel components 10
- Rear panel LEDs and buttons 11
- System board components 12
- System maintenance switch 13
- System board LEDs 14
- Internal USB connector 17
- Fan module location 18
- Server operations 19
- Preparation procedures 20
- Removing the access panel 21
- Installing the access panel 22
- Server operations 23 23
- Removing the fan assembly 25
- Installing the fan assembly 26
- Server setup 27
- Rack planning resources 28
- Optimum environment 29
- Temperature requirements 30
- Power requirements 31
- Rack warnings 32
- Installing hardware options 33
- Server setup 35 35
- Registering the server 36
- Introduction 37
- Memory options 37
- DIMM installation guidelines 38
- Installing DIMMs 38
- Hard drive options 39
- Removing a hard drive blank 40
- Hard drive guidelines 40
- Installing a SATA hard drive 40
- Server cabling 47
- SATA cable routing 48
- SCSI cable routing 49
- Configuration tools 51
- HP ROM-Based Setup Utility 53
- Array Configuration Utility 54
- Management tools 56
- Automatic Server Recovery 57
- ROMPaq utility 57
- Erase Utility 59
- Management Agents 60
- HP Systems Insight Manager 60
- Redundant ROM support 61
- Diagnostic tools 63
- Array Diagnostic Utility 64
- HP Insight Diagnostics 64
- Integrated Management Log 64
- Keeping the system current 65
- Resource Paqs 66
- ProLiant Support Packs 66
- Care Pack 67
- Battery replacement 69
- 5. Remove the battery 70
- Troubleshooting 71
- Important safety information 72
- Warnings and cautions 73
- Troubleshooting 75 75
- Symptom information 76
- Service notifications 77
- Loose connections 77
- Diagnostic steps 77
- Start diagnosis flowchart 78
- Troubleshooting 79 79
- General diagnosis flowchart 80
- Troubleshooting 81 81
- Power-on problems flowchart 82
- Troubleshooting 83 83
- POST problems flowchart 85
- OS boot problems flowchart 87
- Troubleshooting 89 89
- Troubleshooting 91 91
- Other information resources 93
- Electrostatic discharge 95
- FCC rating label 98
- Class A equipment 98
- Class B equipment 99
- Modifications 100
- Mouse compliance statement 100
- Japanese notice 102
- BSMI notice 102
- Korean notice A&B 103
- Laser compliance 103
- Battery replacement notice 104
- Server specifications 107
- Specification 108
- Technical support 109
- Customer self repair 110
- Acronyms and abbreviations 111
- Wake-on LAN 115
Produits connexes et manuels pour Matériel informatique Hp ProLiant DL320 G3 Server
(28 pages)© 2020, manymanuals.fr. Tous droits réservés | 3.615 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels