Hp ProLiant DL360p Gen8 Server Manuel d'utilisateur télécharger pdf (Page 64)

Hardware options installation 64

Connect the power cord to the power supply.

6. Route the power cord through the cable management solution.

7. Connect the power cord to the power source.

8. Be sure that the power supply LED is green ("Rear panel LEDs and buttons" on page 11).

48V DC power supply option

One of the following optional HP input cables with pre-fastened ring tongues may be purchased from HP or

an authorized reseller:

• A5S97A—1.3-m (4.27-ft) 48V DC Power Cable Kit

• A5S98A—2.5-m (8.20-ft) 48V DC Power Cable Kit

If you are not using an optional HP input cable, use an HP-approved 10 or 12 AWG green and yellow

ground cable, no shorter than 150 cm (59.06 in), and 10 or 12 AWG power cables.

To install the component:

1. Remove the blank.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 117 118

Pas de commentaire

Hp ProLiant DL360p Gen8 Server Manuel d'utilisateur Page 64