HP J7949E Manuel d'utilisateur télécharger pdf (Page 181)

ENWW HP Jetdirect Configuration Page 181

PORT CONFIG: Identifies the link configuration of the RJ-45 port on the

HP Jetdirect 10/100Base-TX print server:

10BASE-T HALF: 10 Mbps, half-duplex

10BASE-T FULL: 10 Mbps, full-duplex

100TX HALF: 100Mbps, half-duplex

100TX-FULL: 100Mbps, full-duplex

UNKNOWN: The print server is in an initialization state.

DISCONNECTED: A network connection has not been

detected. Check network cables.

AUTONEGOTIATION Identifies whether IEEE 802.3u Autonegotiation on the

HP Jetdirect 10/100TX port is enabled (ON) or disabled

(OFF).

ON (default): The HP Jetdirect print server will attempt to

automatically configure itself onto the network at the proper

speed (10 or 100 Mbps) and mode (half or full duplex).

Autonegotiation is enabled after a cold reset.

OFF: You must manually configure the speed and mode

using the Jetdirect integrated menu from the printer’s control

panel. If Autonegotiation is off, the settings must match

those of the network for proper operation.

MANUFACTURING ID: The manufacturing identification code for use by HP online

support personnel.

DATE

MANUFACTURED:

Identifies the date of manufacture of the HP Jetdirect print

server.

Table 9.1 HP Jetdirect Configuration (2 of 2)

Message Description

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 231 232

Pas de commentaire

HP J7949E Manuel d'utilisateur Page 181