HP J7949E Manuel d'utilisateur télécharger pdf (Page 31)

ENWW 31

TCP/IP Configuration

Introduction

To operate properly on a TCP/IP network, the HP Jetdirect print

server must be configured with valid TCP/IP network configuration

parameters, such as an IP address that is valid for your network.

For general information on TCP/IP networks, see Appendix A

Server-Based and Manual TCP/IP Configuration

When in a factory-default state and initially powered on, the HP

Jetdirect print server will systematically try to obtain its TCP/IP

configuration using a server-based method (BOOTP, DHCP, and

RARP, described later in this chapter). Up to two minutes are used.

If configuration is not successful, a default IP address will be

assigned.

The print server may also be configured manually. Manual-based

tools include Telnet, a Web browser, the printer control panel, arp

and ping commands (when the default IP address is 192.0.0.192),

or SNMP-based management software. TCP/IP configuration

values assigned manually will be retained when powered off/on.

The print server can be reconfigured to use either server-based or

manual configuration of TCP/IP settings at any time.

To identify the IP address that is configured on the print server at

any time, see the HP Jetdirect configuration page.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 231 232

Pas de commentaire

HP J7949E Manuel d'utilisateur Page 31