HP Compaq 8100 Elite Series Guide de l'utilisateur télécharger pdf (Page 25)

12. To install a new expansion card, hold the card just above the expansion socket on the system

board then move the card toward the rear of the chassis (1) so that the bracket on the card is

aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion

socket on the system board (2).

NOTE: Your computer may look different than the illustration shown below.

Figure 15 Installing an Expansion Card

NOTE: When installing an expansion card, press firmly on the card so that the whole connector

seats properly in the expansion card slot.

13. Rotate the slot cover retention latch back in place to secure the expansion card.

NOTE: Your computer may look different than the illustration shown below.

Figure 16 Closing the Expansion Slot Retainer

14. Connect external cables to the installed card, if needed. Connect internal cables to the system

board, if needed.

ENWW Removing or Installing an Expansion Card 19

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 57 58

Pas de commentaire

HP Compaq 8100 Elite Series Guide de l'utilisateur Page 25