HP Compaq 8100 Elite Series Guide de l'utilisateur télécharger pdf (Page 32)

8. Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided

four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric

guide screws are black. Refer to

Installing and Removing Drives on page 21 for an illustration of

the extra M3 metric guide screws location.

CAUTION: Use only 5-mm long screws as guide screws. Longer screws can damage the internal

components of the drive.

NOTE: When replacing the drive, transfer the four M3 metric guide screws from the old drive to

the new one.

NOTE: Your computer may look different than the illustration shown below.

Figure 23 Installing Guide Screws in the Optical Drive

9. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward

the front of the computer until it locks into place.

NOTE: Your computer may look different than the illustration shown below.

Figure 24 Installing the Optical Drive

26 Hardware Upgrades ENWW

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 57 58

Pas de commentaire

HP Compaq 8100 Elite Series Guide de l'utilisateur Page 32