HP OMNIBOOK 2100 Manuel d'utilisateur télécharger pdf (Page 49)

2-26 Removal and Replacement HP OmniBook 2100/3000/3100

Caution

Use care when removing or installing the USB PCA. Otherwise, you could damage the mating

pins on the motherboard.

5. Remove the screw from the USB PCA, then unplug the PCA from the motherboard by lifting the

front edge.

6. Remove the three screws (one inside the hard drive opening) and three hex standoffs from the

motherboard.

7. Lift the hard drive housing only until the PCMCIA pushbuttons clear the bottom case. Then

gently work the motherboard forward until the I/O bracket slips free.

The audio jack cover is released when you remove the motherboard.

Figure 2-21. Removing the Motherboard

Standoff

USB PCA

LVDS PCA

Screw, M2.5×5mm

CPU Thermal Kit

(pad and spacer),

depends on CPU type

Audio Jack Cover

Lock Plate

Note: Not present on all units.

Screw, M2×5mm

Note smaller diameter

IR Lens

CPU Module

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 106 107

Pas de commentaire

HP OMNIBOOK 2100 Manuel d'utilisateur Page 49