HP ProDesk 600 G3 Base Model Small Form Factor PC Manuel d'utilisateur télécharger pdf (Page 32)

Front bezel dust lter (optional)

Some models are equipped with an optional front bezel dust lter. You must periodically clean the dust lter

so that the dust collected on the lter does not impede air ow through the computer.

NOTE: The optional front bezel dust lter is available from HP.

To remove, clean, and replace the dust lter:

1. Prepare the computer for disassembly (Preparation for disassembly on page 20).

2. To remove the dust lter, use your ngers to separate the lter from the front bezel at the tab locations

shown below.

3. Use a soft brush or cloth to clean dust from the lter. If heavily soiled, rinse the lter clean with water.

4. To replace the dust lter, press the lter rmly onto the front bezel at the tab locations shown below.

24 Chapter 4 Removal and replacement procedures: Small Form Factor

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 149 150

Pas de commentaire

HP ProDesk 600 G3 Base Model Small Form Factor PC Manuel d'utilisateur Page 32