HP ProDesk 600 G3 Base Model Small Form Factor PC Manuel d'utilisateur télécharger pdf (Page 70)

Desktop to tower orientation

The Small Form Factor computer can be used in a tower orientation with an optional tower stand that can be

purchased from HP.

NOTE: To stabilize the computer in a tower orientation, HP recommends the use of the optional tower

stand.

1. Remove/disengage any security devices that prohibit moving the computer.

2. Remove all removable media, such as compact discs or USB ash drives, from the computer.

3. Turn o the computer properly through the operating system, and turn o any external devices.

4. Disconnect the power cord from the AC outlet and disconnect any external devices.

IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long

as the system is plugged into an active AC outlet. To prevent damage to internal components, you must

disconnect the power cord from the power source before opening the computer.

5. Orient the computer so that its right side is facing down and place the computer in the optional stand.

6. Reconnect the power cord and any external devices, and then turn on the computer.

NOTE: Be sure that at least 10.2 centimeters (4 inches) of space on all sides of the computer remains

clear and free of obstructions.

7. Lock any security devices that were disengaged before the computer was moved.

62 Chapter 4 Removal and replacement procedures: Small Form Factor

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 149 150

Pas de commentaire

HP ProDesk 600 G3 Base Model Small Form Factor PC Manuel d'utilisateur Page 70