EN Chapter 7 Troubleshooting 205
TRAY 1 SIZE = [xxxx]
The printer is asking what
size of media has been
loaded in tray 1.
In response, you can take either
of the following actions:
1. Press S
ELECT
to accept the
paper size.
2. Press -V
ALUE
+ to change the
size and then press S
ELECT
to
accept the new size.
The printer will first display the
TRAY 1 TYPE = XXXX
message
(see the description of that
message). If you do not press
any buttons in the time-out period
(about one minute), it displays
this
TRAY 1 SIZE = XXXX
message.
Changing the size here changes
the default for tray 1 paper size in
the paper-handling menu.
TRAY 1 TYPE = [xxxx]
The printer has received a
job under the three
following conditions:
!
The media type
requested by the job is
not available in the
printer.
!
Tray 1 has been set for
CASSETTE.
!
Media has been placed
in tray 1 (thus
triggering tray 1’s
paper sensor).
If you do not press any
buttons, the message
disappears in about one
minute).
You can take either of the
following actions:
1. Press S
ELECT
to accept the
paper type.
2. Press -V
ALUE
+ to change the
type and then press S
ELECT
to
select the new type.
Note
Changing the type here changes
the default for tray 1 media type
in the paper-handling menu.
If you do not do anything during
the time-out period (about one
minute), the printer will print on
the media in tray 1.
UNABLE TO MOPY JOB
Memory or file system
failures would not allow a
mopy job to occur. Only
one copy will be produced.
1. Reseat RAM DIMMs and/or
the EIO hard disk.
2. Install additional memory or an
EIO hard disk.
UNABLE TO STORE JOB
Memory or file system
failures would not allow the
print to store the job.
1. Reseat RAM DIMMs and/or
the EIO hard disk.
2. Install additional memory or an
EIO hard disk.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action
Commentaires sur ces manuels