HP CommonIO Products Manuel d'utilisateur télécharger pdf (Page 28)

Installation

Installing the X.25 Link Software

Chapter 228

Installing the X.25 Link Software

Follow the steps below to install the X.25 link software:

Step 1. Insert the software media (tape or disk) in the appropriate drive.

Step 2. Type: swinstall.

(See the man page on swinstall for more information on this

command).

Step 3. Click on OK on the “Specify Source” window.

Step 4. Highlight J2793B in the “Software Selection” dialog, then select Mark

For Install from the Actions menu to install all file sets in the bundle.

If you want to select only certain file sets, double-click on the product

name to access the file sets that you want to mark for installation (each

time you double-click, you go down one level in the bundle structure).

Step 5. When you have marked the product components you want to install,

select Install (analysis) from the “Actions” menu.

Step 6. When you have successfully completed the analysis, click on OK from the

Analysis dialog to load the X.25 file sets.

The swinstall utility loads the file sets, runs the customized scripts for

the file set, and builds the kernel. Estimated time for processing: 8 to 10

minutes.

If the kernel build is not successful, the swinstall program returns you

to a new shell. The cause of the failure will appear at the end of the

/var/adm/sw/swinstall.log file.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 260 261

Pas de commentaire

HP CommonIO Products Manuel d'utilisateur Page 28