HP CommonIO Products Manuel d'utilisateur télécharger pdf (Page 54)

Configuration

Configuring X.25 over LLC2

Chapter 354

Configuring X.25 over LLC2

This section describes how to configure X.25 over LLC2. Configuring

X.25 over LLC2 allows X.25 layer 3 to connect to DLPI instead of LAP-B

and provides the X.25 functionality on top of LAN cards such as

Ethernet, FDDI, and TokenRing.

NOTE In this document, an XOL interface on the peer or local system is

referred to as “box”.

Configuration Files

To configure the LLC2 feature, the following configuration files must be

added or updated manually:

• Generic X.25 configuration file

• LLC2 specific configuration file

Generic X.25 Configuration file

The generic X.25 configuration file is used with a few additional XOL

specific parameters to configure X.25 over LLC2 (XOL). To support the

XOL HA feature, some of the existing parameter names are modified and

a few new parameters are introduced.

NOTE The parameters introduced in an earlier release of X.25 are supported.

However, HP recommends that you migrate to the new parameters.

Migration is required for XOL HA support.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 260 261

Pas de commentaire

HP CommonIO Products Manuel d'utilisateur Page 54