HP EML Base Library Guide de démarrage rapide télécharger pdf (Page 2)

2. Use the template shipped with the library to mark the front and back

of the rack with the locations of the mounting hardware.

If your library contains LTO4 or LTO5 tape drives or if you plan to

add them later, leave an additional 1U of space above the template

in which to install the switch. HP recommends that you leave 2U of

space above the library for future expansion, if possible.

3. At the front of the rack, install six clip nuts at the locations indicated

on the front of the template. Also install one clip nut in each rail.

4. At the rear of the rack, install four mounting brackets at the locations

indicated on the back of the template. Use two T-15 flathead screws

and washers in each mounting bracket.

5. For the top mounting brackets, place a rail on top of each mounting

bracket. At the front of the rack, attach the rails at the locations

indicated on the front of the template. Use one T-15 flathead screw

and washer in each rail.

3 Install the 8U base module

WARNING!

The 8U base module weighs 27 kg (60 lb). Use two people and

a cart, tabletop, or mechanical device to lift, position, and

secure the 8U base module.

1. Using two people, lift the 8U base module into position in the rack.

The two tabs on each side of the 8U base module fit over the rails.

Slide the 8U base module half way into the rack.

NOTE:

Your library might look different.

Page 2

1 2 3 4 5 6 7 ... 10 11

Pas de commentaire

HP EML Base Library Guide de démarrage rapide Page 2