HP EML Base Library Guide de démarrage rapide télécharger pdf (Page 4)

2. Lift the 4U base module into position in the rack. The top of the 4U

base module has rails on each side that fit into the L-flange of the

module above. The right rail is longer than the left rail, and will

engage first, making the left side heavier until the module is

completely on both rails. Starting with the right side, place the 4U

base module on the L-flange of the 8U base module and slide it

until it is half way into the rack.

3. Open the center doors on the two modules. Align the tongue of the

lower door with the groove in the upper door. Carefully slide the

4U base module into the rack until the doors are engaged.

4. At the rear of the library, guide the notches on the bottom corners

of the 4U base module onto the mounting brackets. Slide the 4U

base module completely into the rack.

5. At the front of the library, remove the 4U blank cover from the 4U

base module. Push down and pull the top of the 4U blank cover

away from the front of the library. Lift the cover off.

6. Attach the 4U base module to the front of the rack with four T-25

panhead screws.

7. Attach the faceplate of the 4U base module to the faceplate of the

8U base module with two 6/32 x 1/4-inch Torx screws.

CAUTION:

Use the correct length screw for this step. The robot will

hit a longer screw when it descends.

8. Replace the 4U blank cover on the 4U base module.

Page 4

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

HP EML Base Library Guide de démarrage rapide Page 4