HP X Unified Security Platform Series Manuel d'utilisateur télécharger pdf (Page 182)

Chapter 6 Network

166 X Family LSM User’s Guide V 2.5.1

This following figure shows the PIM-DM Setup page:

Enable PIM-DM globally

STEP 1

Check Enable PIM-DM.

STEP 2

Enter a value between 1 and 600 seconds (default 30 seconds) for the Query Interval.

STEP 3

Optionally, enter a value between 1 and 900 seconds (default 180 seconds) for the Prune

Timeout.

Prune Timeout alleviates some PIM-DM flood problems. A prune delay is introduced,

allowing the first multicast packet to flood to all sites. Subsequent multicast packets to that

multicast group are then dropped until most prunes have returned from remote devices,

when the multicast stream is released again.

STEP 4

Click Apply to save the change.

Edit PIM-DM Configuration on an IP Interface

STEP 1

From the LSM menu, select Network > Configuration > PIM-DM.

STEP 2

On the PIM-DM Setup page in the IP Interfaces Setup table, click the Edit icon for the inter-

face you want to edit. Then, configure PIM-DM for the interface.

STEP 3

Enable Firewall Rules to allow PIM-DM to/from this-device for the relevant zones.

For more information on configuring interfaces, see “Enable Multicasting on an IP Interface”

on page 153.

Figure 6–13: Network Configuration: PIM-DM Setup Page

Note You must enable PIM-DM globally in order to run it on an interface.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 332 333

Pas de commentaire

HP X Unified Security Platform Series Manuel d'utilisateur Page 182