HP ENWW Guide de l'utilisateur télécharger pdf (Page 31)

Envelopes with double-side seams

An envelope with double-side-seam construction has vertical seams at both ends of the envelope rather

than diagonal seams. This style might be more likely to wrinkle. Make sure that the seam extends all

the way to the corner of the envelope as shown in the following illustration:

1 acceptable envelope construction

2 unacceptable envelope construction

Envelopes with adhesive strips or flaps

Envelopes with a peel-off adhesive strip or with more than one flap that folds over to seal must use

adhesives compatible with the heat and pressure in the printer: 200° C (392° F). The extra flaps and

strips might cause wrinkling, creasing, or jams.

Envelope storage

Proper storage of envelopes contributes to good print quality. You should store envelopes flat. If air is

trapped in an envelope, creating an air bubble, the envelope might wrinkle during printing.

Card stock and heavy media

You can print many types of card stock from the paper input tray, including index cards and postcards.

Some card stock performs better than others because its construction is better suited for feeding through

a laser printer.

For optimum printer performance, do not use paper heavier than 157 g/m

(42 lb). Paper that is too

heavy might cause misfeeds, stacking problems, paper jams, poor toner fusing, poor print quality, or

excessive mechanical wear.

NOTE You might be able to print on heavier paper if you do not fill the input tray to capacity

and if you use paper with a smoothness rating of 100-180 Sheffield.

ENWW Guidelines for using media 21

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 157 158

Pas de commentaire

HP ENWW Guide de l'utilisateur Page 31