HP ENWW Guide de l'utilisateur Page 32
- Page / 158
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Card stock construction
●
Smoothness: 135-157 g/m
2
(36-42 lb) card stock should have a smoothness rating of
100-180 Sheffield. 60-135 g/m
2
(16-36 lb) card stock should have a smoothness rating of
100-250 Sheffield.
●
Construction: Card stock should lie flat with less than 5 mm (0.2 in.) of curl.
●
Condition: Make sure that the card stock is not wrinkled, nicked, or otherwise damaged.
●
Sizes: Only use card stock within the following size ranges:
●
Minimum: 76 x 127 mm (3 x 5 in.)
●
Maximum: 216 x 356 mm (8.5 x 14.0 in.)
Card stock guidelines
Set margins at least 2 mm (0.08 in.) away from the edges.
Letterhead and preprinted forms
Many manufacturers now offer premium paper advertised as laser-compatible or laser-guaranteed.
Some of the rougher surface finishes, such as cockle, laid, or linen, might require the special fuser
modes that are available on some printer models in order to achieve adequate toner adhesion.
NOTE Some page-to-page variation is normal when printing with laser printers. This variation
cannot be observed when printing on plain paper. However, this variation is obvious when printing
on preprinted forms because the lines and boxes are already placed on the page.
To avoid problems when using preprinted forms, embossed paper, and letterhead, observe the following
guidelines:
●
Avoid using low-temperature inks (the kind used with some types of thermography).
●
Use preprinted forms and letterhead paper that have been printed by offset lithography or
engraving.
●
Use forms that have been created with heat-resistant inks that will not melt, vaporize, or release
undesirable emissions when heated to 200° C (392° F) for 0.1 second. Typically, oxidation-set or
oil-based inks meet this requirement.
●
When the form is preprinted, be careful not to change the moisture content of the paper, and do
not use materials that change the paper's electrical or handling properties. Seal the forms in
moisture-proof wrap to prevent moisture changes during storage.
●
Avoid processing preprinted forms that have a finish or coating.
●
Avoid using heavily embossed or raised-letterhead papers.
●
Avoid papers that have heavily textured surfaces.
●
Avoid using offset powders or other materials that prevent printed forms from sticking together.
22 Chapter 4 Supported paper and other media ENWW
- HP LaserJet P2015 Series 1
- Table of contents 5
- 1 Product information 11
- Product features 12
- HP LaserJet P2015n printer 13
- HP LaserJet P2015dn printer 13
- HP LaserJet P2015x printer 13
- Identify product parts 14
- ENWW Identify product parts 5 15
- 2 Control panel 17
- 3 Product software 19
- Supported operating systems 20
- Printer connections 21
- Software for Windows 23
- HP ToolboxFX 24
- Embedded Web server 24
- Software for Macintosh 25
- Table 4-1 Driver print modes 28
- Guidelines for using media 29
- Transparencies 30
- Envelopes 30
- Card stock and heavy media 31
- Card stock construction 32
- Card stock guidelines 32
- 5 Print tasks 33
- Load media 34
- Manual feed 35
- Print-quality settings 36
- Print on special media 37
- Manual two-sided printing 42
- Automatic two-sided printing 48
- Print booklets 51
- Print watermarks 52
- Cancel a print job 53
- 6 Managing and maintenance 55
- Printer information pages 56
- Set up status alerts 59
- Set up e-mail alerts 59
- Device settings 60
- Paper handling 61
- Print quality 61
- Paper types 61
- Print settings 62
- Network settings 63
- Status tab 65
- Settings tab 65
- Networking tab 65
- Replace the print cartridge 67
- Redistribute toner 69
- Clean the printer 70
- Clean the printer media path 71
- 3. Remove tray 2 76
- 9. Remove the pickup roller 79
- EconoMode 82
- 7 Problem solving 83
- Finding the solution 84
- Contact HP support 85
- Status-light patterns 86
- ENWW Status-light patterns 77 87
- ENWW Status-light patterns 79 89
- ENWW Status-light patterns 81 91
- Common Macintosh problems 93
- Media problem solving 97
- Problem Cause Solution 98
- Graphics quality 100
- Printer software problems 101
- Improve print quality 102
- Vertical lines 103
- Gray background 103
- Toner smear 103
- Misformed characters 104
- Loose toner 104
- Vertical repetitive defects 104
- Page skew 105
- Curl or wave 105
- Wrinkles or creases 105
- Toner scatter outline 106
- Clearing jams 107
- Input trays 109
- 6. Open tray 2 111
- ENWW Clearing jams 101 111
- Output bin 112
- Straight-through output path 113
- 7. Reinsert tray 2 117
- ENWW Clearing jams 107 117
- Network setup problem solving 119
- HP print cartridges 124
- DIMMs (memory or font) 125
- Test the DIMM installation 127
- Remove a DIMM 127
- 2. Open the DIMM door 128
- 5. Close the DIMM door 129
- B Service and support 131
- Hardware service 132
- Extended warranty 132
- How to contact HP 133
- C Printer specifications 135
- Environmental specifications 136
- Acoustic emissions 136
- Electrical specifications 137
- Physical specifications 139
- Memory specifications 140
- Port availability 140
- D Regulatory information 141
- FCC compliance 142
- Regulatory statements 144
- Laser statement for Finland 145
- Material restrictions 147
- European Union 147
- Material safety data sheet 148
- For more information 148
- E Warranty and licensing 149
- CB366-90951 158
Produits connexes et manuels pour PC/postes de travail HP ENWW
PC/postes de travail HP 7800 Spécifications
(102 pages)
(102 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.082 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels