Hp 3300mfp Manuel d'utilisateur Page 168

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 259
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 167
166 12 Troubleshooting printing problems EN
Alert messages
The following messages are generic alert messages that may appear in the control panel display.
Printer Mispick (Enter) To Resume
Printer Jam. Clear Paper Path
Door Open Or No Print Cartridge
Printer Tray Is Empty. Add Paper
Document Feeder Mispick. Reload
Doc Feeder Jam. Clear, Reload
Memory Low. Press [Cancel]
Alert messages communicate to the user that some action must be performed, such as adding
paper or clearing a jam. When an alert message appears, the product will automatically stop the
current task, display the error message, and wait for the user to attend to the situation. Once the
user has corrected the error, the device will either complete the task or go back to the Ready state.
The exception to this rule is when the user wants to enter the main menu system. In this instance
the device will change the display and allow the user to enter the menu system.
Note If the alert message pertains to clearing a jam, see Clearing media jams for more information.
Warning messages
The following messages are generic warning messages that may appear in the control panel
display.
Not Enough Memory. Try Later
Device Busy. Try Again Later
Settings Cleared
Device Error. [Enter] To Cont.
Page Too Complex [Enter] To Cont.
Warnings are messages that are important enough that the user must be notified. They are
transient in nature, but may affect the completion of the task or the quality of the output. When a
warning message appears, the active job might cancel. The message will display for five seconds.
If the warning messages are related to print, and the auto continue setting is on, the message will
display for 10 seconds. If there is no response from the user by either pressing enter/menu or
cancel, the device will continue processing the print job. If auto continue is off, the print related
warning messages will display until the user has either pressed enter/menu to proceed or cancel
to cancel the job.
Note Auto continue is set in the printer driver. To find out whether auto continue is enabled, print a
configuration page. See Printing a configuration page for more information.
Vue de la page 167
1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 258 259

Commentaires sur ces manuels

Pas de commentaire