HP 2000s Guide de l'utilisateur télécharger pdf (Page 54)

Storage Management Overview

54 NAS 2000s Administration Guide

Volumes

When planning dynamic disks and volumes there is a limit to the amount of growth a single

volume can undergo. Volumes are limited in size and are limited to no more than 32 separate

LUNs with each LUN not exceeding 2 terabytes (TB). Volumes also cannot exceed 64 TB of

disk space.

The RAID level of the LUNs included in a volume must be considered. All of the units that

make up a volume should have the same high-availability characteristics. In other words, the

units should all be of the same RAID level. For example, it would be a bad practice to include

both a RAID 1+0 and a RAID 5 array in the same volume set. By keeping all the units the

same, the entire volume retains the same performance and high-availability characteristics,

making managing and maintaining the volume much easier. It should be noted that if a

dynamic disk goes offline, then the entire volume dependent on the one or more dynamic disks

is unavailable. There could be a potential for data loss depending on the nature of the failed

LUN.

Volumes are created out of the dynamic disks and can be expanded on the fly to extend over

multiple dynamic disks if they are spanned volumes. However, once a type of volume is

selected it cannot be altered. For example, a spanning volume cannot be altered to a mirrored

volume without deleting and recreating the volume, unless it is a simple volume. Simple

volumes can be mirrored or converted to spanned volumes. Fault tolerant disks cannot be

extended either. Therefore, selection of the volume type is important. Please note that the same

performance characteristics on numbers of reads and writes apply when using fault tolerant

configurations as is the case with controller based RAID. These volumes can also be assigned

drive letters or be mounted as mount points off existing drive letters. In general, HP

recommends utilizing the Array controller for the management of fault tolerance over the use

of DM since DM places an additional level of operating system overhead on volumes. If

mount points are utilized, it should be noted that Services for Unix does not support mount

points at this time.

The administrator should carefully consider how the volumes will be carved up and what

groups or applications will be using them. For example, putting several storage-intensive

applications or groups into the same dynamic disk set would not be efficient. These

applications or groups would be better served by being divided up into separate dynamic disks,

which could then grow as their space requirements increased, within the allowable growth

limits.

Utilizing DM Storage Elements

No matter which type of storage element is created in DM the last step in creating the element

is determining its drive letter or mount point and formatting the element. Each element created

can exists as a drive letter(s), assuming one is available and/or as mount points off of an

existing folder of a drive letter. Either method is supported. However, mount points can not be

utilized for shares that will be shared using Microsoft Services for Unix (NFS). They can be

setup with both but the use of the mount point in conjunction with NFS shares causes

instability with the NFS shares.

Formats consist of NTFS, FAT32, and FAT and all three types can be used on the NAS device.

However, the Volume Shadow Copy Service can only utilize volumes that are NTFS

formatted. Also, quota management is possible only on NTFS.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 199 200

Commentaires sur ces manuels

Pas de commentaire

Corbero 6040MF Bedienungsanleitung (9 Seiten)

Marke: Corbero | Kategorie: No info | Größe: 0.06 MB |

Inhaltsverzeichnis

EINBAU- GLASKERAMIKKOCHFELD

ZKF 326 X

INHALTSVERZEICHNIS

TECHNISCHE DATEN

HINWEISE - KOCHMULDEN

ANWEISUNGEN FÜR DEN BENUTZER

REINIGUNG

POSITION

ELEKTRISCHER ANSCHLUSS

DER EINBAU IN MÖBEL

WARTUNG - KUNDENDIENST

Weitere Produkte und Handbücher für Nein CORBERO

Modelle	Dokumententyp
5030HGB4	Bedienungsanleitung Corbero 5030HGB4 Manual de usuario, 16 Seiten
EMM1872	Bedienungsanleitung Electrolux EMM1872 Manuale utente [el] [es] [nl] [pt] , 21 Seiten
V-140I	Bedienungsanleitung Corbero V-140I Manual de usuario, 10 Seiten
5040HGICB	Bedienungsanleitung Corbero 5040HGCN Manual de usuario, 14 Seiten
ZCG75DCX	Bedienungsanleitung Corbero ZCG75DCX Manual de usuario [bs] [hr] [sk] , 20 Seiten
EN404I/2	Bedienungsanleitung Corbero EN404I/2 Manual de usuario [et] [it] [lv] , 12 Seiten
LVC82S	Bedienungsanleitung Corbero LVC82S Manual de usuario, 20 Seiten
LVC31S	Bedienungsanleitung Corbero LVC31S Manual de usuario [ru] , 12 Seiten
V144DN	Bedienungsanleitung Corbero V144DN Manual de usuario [es] [it] [pl] [pt] [ro] , 22 Seiten
CV850S/2	Bedienungsanleitung Corbero CV850S/2 User Manual [da] [sv] , 18 Seiten
5540HGN4	Bedienungsanleitung Corbero 5540HGB4 Manual de usuario, 16 Seiten
8550HGIL4	Bedienungsanleitung Corbero 8550HGIL4 Manual de usuario [de] [it] [pt] , 20 Seiten
HB1031A	Bedienungsanleitung Corbero HB1031A Manual de usuario, 20 Seiten
ZH84W/ZHM	Bedienungsanleitung ZANUSSI ZH84X/ZHM Instrukcja obsługi [en] , 20 Seiten
LVE8010PB	Bedienungsanleitung Corbero LVE8010PB Manual do usuário [el] [fr] [pl] [ro] [sk] [sk] , 16 Seiten
5040HGICB7	Bedienungsanleitung Corbero 5040HGICN7 Manual de usuario, 20 Seiten
6054VT	Bedienungsanleitung Corbero 6054VT Manual de usuario [es] , 16 Seiten
V-142N	Bedienungsanleitung Corbero V-142I Manual de usuario, 12 Seiten
8550HGB4	Bedienungsanleitung Corbero 8550HGB4 Manual de usuario [en] , 20 Seiten
5040HGRCB4	Bedienungsanleitung Corbero 5040HGRCB4 Manual de usuario [sl] , 16 Seiten