Hp Insight Management Agents Manuel d'utilisateur Page 95

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 177
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 94
Cleaning Tape Needs Replacement—Indicates the cleaning tape associated with the autoloader
is at the end of the tape. If the cleaning tape is at the end of the tape, a new cleaning tape
must be placed in the autoloader.
NOTE: A value of “Not Supported” indicates that the tape drive does not support this feature.
You might need to upgrade your firmware to the latest revision.
Number of Cleanings Performed—Indicates the number of times that the tape drive has been
cleaned. If a tape drive is cleaned too much it can damage the tape heads.
NOTE: A value of Not Supported indicates that the tape drive does not support this feature.
CD storage system
Select the CD Storage System entry in the SCSI controller submenu to display Library Information
and information for CD-ROM drives associated with the storage system.
CD Library Information
Select the Library Information entry from the CD Storage System list to display the following
information:
Status—Displays the current fault light status of the CD Library. The following values are valid:
OK—The library is operating normally.
Failed—Indicates that the CD library fault light is in a failed state. The fault light is activated
for hardware errors (Sense Code 04h) with additional Sense codes—40h-4fh except the
parity error. The LED remains illuminated until it is power cycled.
Unknown—The state of the library cannot be determined.
Vendor—Displays the vendor name for the CD Library. This item can be used for identification
purposes.
Model—Displays the model name of the CD Library. This value can be used for identification
purposes.
Serial Number—Displays the serial number of the CD Library. This value can be used for
identification purposes.
Firmware Version—Displays the firmware revision of the CD Library.
CD-ROM drive information
Select a CD-ROM drive from the CD Storage System list to display the following information:
Vendor—Displays the vendor name for the CD-ROM drive
Model—Displays the model name of the CD-ROM drive
Firmware Rev—Displays the firmware revision of the CD-ROM drive
LUN—Displays the logical unit number of the CD-ROM drive
Storage agent 95
Vue de la page 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 176 177

Commentaires sur ces manuels

Pas de commentaire