Hp ProLiant Support Pack Manuel d'utilisateur télécharger pdf (Page 15)

Deploying PSPs 15

NOTE: Ensure that each NIC has an IP address assigned. To get the IP address assigned to a

NIC, issue the dhclient command in the console, which enables the NIC interfaces and

retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start

up.

o RHEL6 Console Mode:

NOTE: You cannot use an X console in either the x86 or x86_64 version. You must install the

base server with defaults and the following RPMs listed to run HP SUM in silent mode.

— lm_sensors-libs-3.1.1-10.el6.<arch>.rpm

— net-snmp-libs-5.5-27.el6.<arch>.rpm

— net-snmp-5.5.27.el6.<arch>.rpm

— kernel-headers-2.6.32-71.el6.<arch>.rpm

— redhat-rpm-config-9.0.3-25.el6.noarch.rpm

— kernel-devel-2.6.32-71.el6.<arch>.rpm

— rpm-build-4.8.0-12.el6.<arch>.rpm

— gcc-4.4.4-13.el6.<arch>.rpm

o RHEL6 Graphical Mode:

NOTE: If you elect to install the XWindows support, then RHEL6 Graphical Mode applies to both

x86 and x86_64.

NOTE: The following items must be the 32-bit version even under x86_64 architecture as HP

SUM and several of the RPMs require 32-bit libraries installed.

— libuuid-2.17.2-6.el6.i686.rpm

— freetype-2.3.11-5.el6.i686.rpm

— libSM-1.1.0-7.1.el6.i686.rpm

— libICE-1.0.6-1.el6.i686.rpm

— libXi-1.3-3.el6.i686.rpm

— libX11-1.3-2.el6.i686.rpm

— libXext-1.1-3.el6.i686.rpm

— libxcb-1.5-1.el6.i686.rpm

— libXau-1.0.5-1.el6.i686.rpm

— libXrender-0.9.5-1.el6.i686.rpm

— libXrandr-1.3.0-4.el6.i686.rpm

— libXfixes-4.0.4-1.el6.i686.rpm

— libXcursor-1.1.10-2.el6.i686.rpm

— fontconfig-2.8.0-3.el6.i686.rpm

— expat-2.0.1-9.1.el6.i686.rpm

— expect-5.44.1.15-2.el6.<arch>.rpm

— zlib-1.2.3-25.el6.i686.rpm

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Pas de commentaire

Hp ProLiant Support Pack Manuel d'utilisateur Page 15