HP Remote Graphics Software (RGS) Manuel d'utilisateur télécharger pdf (Page 148)

Figure 6-16 Prior to remote attachment of the USB drive key

To connect the USB drive key to a Remote Computer in Directory Mode, perform the following steps:

1. Click the USB tab on the Receiver Control Panel.

2. Click the Enable Remote USB checkbox to enable the remote USB connection.

3. Select the IP address (or hostname) of the Remote Computer, and click Connect.

4. Once connection has been established, remove and re-insert the USB drive key—this step is

required to initiate the remote USB attachment.

As shown in

Figure 6-17 After remote attachment of the USB drive key on page 130, the USB drive

key is now attached to the Remote Computer, and is no longer available to the Local Computer.

Figure 6-17 After remote attachment of the USB drive key

6.5.2 USB session switching

New with RGS 5.1.3 is the ability to dynamically move USB devices from one Remote Computer to

another. This enables USB devices to be detached from one Remote Computer, and made accessible

by another Remote Computer without first needing to disconnect the RGS connections. To move USB

devices to a different Remote Computer in Directory Mode, simply specify the new Remote Computer

(Sender) in the Select sender: dropdown menu (see

Figure 6-18 Dynamically moving USB devices to

130 Chapter 6 Advanced capabilities ENWW

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 258 259

Pas de commentaire

HP Remote Graphics Software (RGS) Manuel d'utilisateur Page 148