Hp Smart Update Manager (User Guide) Manuel d'utilisateur télécharger pdf (Page 36)

The following table shows what updates occur if WBEM switches are currently installed.

Gen8 serversG7 and earlier serversCommand

WBEMWBEMno switches

WBEM and AMSWBEM/use_ams

WBEM and SNMPWBEM and SNMP/use_snmp

WBEMWBEM/use_wmi

AMS, SNMP, and WBEMWBEM and SNMP/use_ams /use_snmp

WBEM and AMSWBEM/use_ams /use_wmi

WBEM and SNMPWBEM and SNMP/use_wmi /use_snmp

AMS, SNMP, and WBEMWBEM and SNMP/use_ams /use_wmi /use_snmp

The following table shows what updates occur if AMS switches are currently installed.

Gen8 serversG7 and earlier serversCommand

AMSN/Ano switches

AMSN/A/use_ams

AMS and SNMPN/A/use_snmp

AMS and WBEMN/A/use_wmi

AMS and SNMPN/A/use_ams /use_snmp

AMS and WBEMN/A/use_ams /use_wmi

AMS, SNMP, and WBEMN/A/use_wmi /use_snmp

AMS, SNMP, and WBEMN/A/use_ams /use_wmi /use_snmp

NOTE: G7 and earlier servers do not support AMS.

Command-line arguments

HP SUM recognizes the following command-line arguments, which you can use to pre-populate

the GUI on the Source Selection and Review/Install Updates screens. If you specify the target and

credentials, use the /s[ilent] parameter to proceed with the installation.

You cannot use some arguments, such as /romonly and /softwareonly, together.

DescriptionHelp

Displays command line help information./h[elp] or /?

DescriptionInstallation options

Overrides or downgrades an existing component

installation. This produces the same results as

/f:software.

/f[orce]

Overrides or downgrades the existing installation of

components in the selected bundle.

/f[orce]:bundle

Overrides or downgrades the existing installation of the

selected firmware components (applies to firmware only).

/f[orce]:rom

36 Using scripts to deploy updates

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 84 85

Pas de commentaire

Hp Smart Update Manager (User Guide) Manuel d'utilisateur Page 36