HP X9300 Guide d'installation télécharger pdf (Page 59)

25. The wizard is ready to create the cluster. Note the situations listed on the Proceed to Cluster

Creation dialog box, and select Exit if they apply to you. Otherwise, select Proceed.

Creating the cluster on blade 1

To create the cluster on blade 1, complete the following steps:

1. On the Form a Cluster — Step 2 dialog box, enter a name for the cluster and specify the IP

address and netmask for the Management Console IP (also called the Cluster Management

IP). This IP address runs on a virtual interface (VIF) assigned to the entire cluster for management

use. Think of it as the “IP address of the cluster.” You should connect to this VIF in future GUI

management sessions. The VIF remains highly available.

NOTE: If you are using a 2, 3, or 4 network layout, install this IP on the bond1 network.

Also enter the IP addresses and domain for your DNS servers, and the IP addresses for your

NTP servers.

Creating the cluster on blade 1 59

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 150 151

Pas de commentaire

HP X9300 Guide d'installation Page 59