Hp Hitachi Dynamic Link Manager Software Manuel d'utilisateur Page 160

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 746
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 159
3. Creating an HDLM Environment
136
configuration, memory might become insufficient due to the HAL daemon
#
. In
this case, the host will not respond.
To avoid this, stop the HAL daemon when executing the
dlmcfgmgr utility. The
following procedure shows how to stop the HAL daemon.
#
The HAL daemon detects hardware configurations changes, for example,
when a USB device or CD-ROM is inserted.
To stop the HAL daemon:
1. Check the status of the HAL daemon.
Execute the
/sbin/service command to check the HAL daemon status. If
the daemon is running,
running will appear.
# /sbin/service haldaemon status
If the daemon is not running,
stopped will appear.
2. Check the result of step 1. If the HAL daemon is running, stop the daemon.
Execute the
/sbin/service command to stop the HAL daemon. Note that
it might take a while to stop the daemon completely.
# /sbin/service haldaemon stop
3. Make sure that the HAL daemon is stopped.
Execute the
/sbin/service command to make sure that the HAL daemon
is not running.
# /sbin/service haldaemon status
4. Execute the dlmcfgmgr utility (
dlmcfgmgr -r or dlmcfgmgr -i) to
configure the HDLM device.
# /sbin/dlmcfgmgr -r
or
Vue de la page 159
1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 745 746

Commentaires sur ces manuels

Pas de commentaire