Hp XP Continuous Access Software Manuel d'utilisateur télécharger pdf (Page 162)

162 HP StorageWorks Disk Array XP RAID Manager: User’s Guide

pairmon

Report pair transition status

Description The pairmon command is sent to the RM (daemon) to report the transition

of pairing status. When an error or status transition is detected, this

command outputs an error message.

Events exist on the pair state transfer queue for RM. Resetting an event

correlates to the deletion of one or all events from the pair state transfer

queue. If the command does not reset, the pair state transfer queue is

maintained.

The table below shows the results of pairmon argument combinations.

–D –nowait –resevt –allsnd Actions

–D When RM does not have an event, this option waits until an

event occurs. If more events exist, it reports one event.

This option clears the event that it reports.

Invalid –allsnd When RM does not have an event, this option waits until an

event occurs. If more than one event exists, it reports all

events without clearing them.

Invalid –resevt When RM does not have an event, this option waits until an

event occurs. If multiple events exist, it reports one event

and resets (clears) all events.

Invalid –resevt –allsnd When RM does not have an event, this option waits until an

event occurs. If multiple events exist, it reports all events

and then clears them.

Invalid –nowait When RM does not have an event, this option reports “no

event” immediately. If multiple events exist, it reports one

event.

This option resets (clears) the event which it reported.

Invalid –nowait –allsnd When RM does not have an event, this option reports “no

event” immediately. If more events exist, then it reports all

events.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 411 412

Pas de commentaire

Hp XP Continuous Access Software Manuel d'utilisateur Page 162