Hp XP Continuous Access Software Manuel d'utilisateur télécharger pdf (Page 132)

• Path Watch Time (min): Time for monitoring blockade of paths to the remote array. If the

status of a mirror where secondary data volumes in the local array are registered is Hold or

Hold(Failure), this column is blank.

• Volume: Number of data volumes registered in the mirror.

• Capacity: Total capacity of data volumes registered in the mirror.

• Previous: Displays detailed information about the previous journal group.

• Next: Displays detailed information about the next journal group.

• Close: Closes the JNL Group Detail pane.

Changing opt

ions for journal groups

If you are log

ged onto an XP10000, you can perform this operation only on journal groups that have

anumberbelow10.

To change a journal group's options, the primary and secondary array administrators must perform the

following procedure:

1. Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,

see the HP St

orageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks

XP Remote W

eb Console user guide for XP12000/XP10000/SVS200.

2. Display the Journal Operation pane (see Displaying the Journal Operation pane).

3. Do one of the following:

• In the tree, right-click a journal group from below Registered,andselectJNL Groups and

Change JN

LOption.

• In the upper-right list, right-click the desired journal group, and select JNL Groups and

Change JNL Option.

CAUTION:

You can select Change JNL Option only when one of the following conditions is satisﬁed:

•Journal

group's attribute is Initial.

• Journal group's status is Stop.

• Journal group's status is Active.

•Status

of the journal group is Hold.

• Status of the journal group is Hold(Failure).

When one journal group uses multiple mirror IDs, whether or not you can Change JNL Option

depends on the status of the journal group whose mirror is not in Hold or Hold(Failure) status.

4. IntheChangeJNLOptionpane(Figure 54), change journal group options, and click Set.

CAUTION:

If the journal group's status is Active or if the master journal group's status is Hold,you

can change only the Line of Speed option.

NOTE:

If you selected two or more journal groups in step 3 and want to leave some options in

the Change JNL Options pane unchanged, specify blank for the options. If you specify

blank for an option, the option value remains unchanged. If you specify a value other than

blank, the speciﬁed value is set to the selected journal groups.

5. In the Preset list, check the settings you made.

132

Using journal groups

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 233 234

Commentaires sur ces manuels

Pas de commentaire

Hp XP Continuous Access Software Manuel d'utilisateur Page 132

Commentaires sur ces manuels

Produits connexes et manuels pour Stockage Hp XP Continuous Access Software