Hp PROCURVE 2610 Manuel d'utilisateur télécharger pdf (Page 51)

2-27

Installing the Switch

Installation Procedures

Installing the Switch

Direct Console Access

To connect a console to the

switch, follow these steps:

1. Connect the PC or

terminal to the switch’s

Console Port using the

console cable included

with the switch. (If your

PC or terminal has a 25-pin

serial connector, first

attach a 9-pin to 25-pin

straight-through adapter

at one end of the console

cable.)

2. Turn on the terminal or

PC’s power and, if using a

PC, start the PC terminal

program.

3. Press

[Enter] two or three

times and you will see the copyright page and the message “Press any key

to continue”. Press a key, and you will then see the switch console

command (CLI) prompt, for example:

ProCurve Switch #

If you want to continue with console management of the switch at this time,

see chapter 3, “Getting Started With Switch Configuration” for some basic

configuration steps. For more detailed information, refer to the Management

and Configuration Guide, which is on the ProCurve Web site at www.hp.com/

go/procurve/manuals, (See page 1-13).

Console port

Console cable supplied

with the switch

PC running a terminal

emulator program, or

a VT-100 terminal

Figure 2-19. Connecting the console cable

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 111 112

Pas de commentaire

Hp PROCURVE 2610 Manuel d'utilisateur Page 51