Hp DL120 Manuel d'utilisateur télécharger pdf (Page 80)

Diagnostic tools 80

To remove the supervisor password:

1. In the Security menu screen, select the Supervisor Password Is field, and then press Enter.

2. Type the original password then press Enter.

3. Press Enter twice without entering anything in the new and confirm password fields.

4. Press F10 to save the changes you made and close the Setup Utility.

The

Supervisor Password Is field value is set to Clear.

To reset the supervisor password:

If you forget the supervisor password, you need to clear the CMOS and reset the BIOS settings to

regain access the Setup Utility. For instructions, refer to the

“Clearing CMOS” section on page 84.

Boot menu

Use this menu to set the preferred drive sequence in which the Setup Utility attempts to boot the

operating system.

By default, the server searches for boot devices in the following order:

• CD-ROM/DVD-ROM drive

• Removable device

• Hard drive

• Embedded NIC (via Preboot Execution Environment—remote boot over LAN)

To implement the PXE boot option, you need to first set the Embedded NIC1 PXE field to Enabled.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 107 108

Pas de commentaire

Hp DL120 Manuel d'utilisateur Page 80