EN Chapter 7 Troubleshooting 213
52.X PRINTER ERROR
alternates with
CYCLE POWER TO
CONTINUE
The laser scanner speed is
incorrect.
X description:
1 = Scanner startup error
2 = Scanner rotation error
1. Press G
O
. The page containing
the error will automatically be
reprinted.
2. Turn the printer off and then
on.
3. Reseat cables to the laser/
scanner and engine controller.
4. Replace the laser/scanner.
53.XY.ZZ PRINTER
ERROR
There is a memory error
with an accessory. The
DIMM that caused the
error will not be used.
Values of
X
,
Y
, and
ZZ
are
as follows:
X = DIMM type
0 = ROM
1 = RAM
Y = Device location
0 = internal memory
(ROM or RAM)
1 to 4 = DIMM slots
1, 2, 3, or 4
ZZ = Error number
0, 1, 2 = Unsupported o
unrecognized memory
3 = Failed RAM test
4, 5 = Exceeded
maximum RAM or ROM
size
6 = Invalid DIMM speed
7 = DIMM reporting
information incorrectly
8 = DIMM RAM parity
error
9 = ROM needs to be
mapped to an
unsupported address
10 = DIMM address
conflict
11 = PDC XROM out of
bounds
12 = Unable to make a
temporary mapping
1. Turn the printer off, and reseat
or replace the specified DIMM.
2. Try the DIMM in another slot.
(The firmware DIMM must remain
in slot #4—the lowest DIMM slot.)
3. Replace the DIMM that caused
the error.
54.1 REMOVE SEALING
TAPE
alternates with
FROM TONER
CARTRIDGE
The toner cartridge has
been installed without
removing the sealing tape.
1. Open the top cover and
remove the toner cartridge.
2. Pull the sealing tape tab to
remove the strip.
3. Reinstall the toner cartridge
and close the top cover.
Table 37. Printer messages (continued)
Control panel
message
Explanation Recommended action
Commentaires sur ces manuels