242 Troubleshooting EN
Repeating
image
This type of defect might occur
when using preprinted forms, a
large quantity of narrow media, or
a fuser mode that is set too high
for your media.
1. Print a few more pages and
see if the problem corrects itself.
2. Make sure that print media
type and quality meet HP
specifications.
3. If you observe that this type of
defect occurs on wide paper
(such as letter or A4-size paper)
just after printing on narrow
media (such as envelopes), you
can set
SMALL PAPER SPEED
on
the paper-handling menu to
SLOW
.
Note that this will slow down
printing.
4. Check your fuser mode.
Maintenance due Print a copy of the supplies status
page. If maintenance is due,
order and install the printer
maintenance kit.
Misformed
characters
Printer’s operating environment
does not meet specifications.
1. Print a few more pages to see
if the problem corrects itself.
2. Make sure that the
environmental specifications for
the printer are being met.
Maintenance due Print a copy of the supplies status
page. If maintenance is due,
order and install the printer
maintenance kit.
Tire tracks Toner cartridge is worn out. 1. Replace the toner cartridge
after 6,000 or 10,000 pages,
depending on the type of toner
cartridge that is installed in the
printer.
2. Reduce the number of pages
that you print with very low toner
coverage.
3. Use the 6,000-page cartridge if
you cannot reduce the number of
pages that have very little toner
coverage.
Table 42. Image defects
Problem Cause Solution
Commentaires sur ces manuels